This article describes the implementation of a new numerical model of the power take-off system installed in the Monterey Bay Aquarium Research Institute wave energy converter, a device developed to provide power to various oceanic research missions. The simultaneous presence of hydraulic, pneumatic, and electrical subsystems in the power take-off system represents a significant challenge in forging an accurate model able to replicate the main dynamic characteristics of the system. The validation of the new numerical model is addressed by comparing simulations with the measurements obtained during a series of bench tests. Data from the bench tests show good agreement with the numerical model. The validated model provides deeper insights into the complex nonlinear dynamics of the power take-off system and will support further performance improvements in the future.
Hwang, Joonsik; Karathanassis, Ioannis K.; Koukouvinis, Phoevos; Nguyen, Tuan; Tagliante, Fabien; Pickett, Lyle M.; Sforzo, Brandon A.; Powell, Christopher F.
As modern gasoline direct injection (GDI) engines utilize sophisticated injection strategies, a detailed understanding of the air-fuel mixing process is crucial to further improvements in engine emission and fuel economy. In this study, a comprehensive evaluation of the spray process of single-component iso-octane (IC8) and multi-component gasoline surrogate E00 (36 % n-pentane, 46 % iso-octane, and 18 % n-undecane, by volume) fuels was conducted using an Engine Combustion Network (ECN) Spray G injector. High-speed extinction, schlieren, and microscopy imaging campaigns were carried out under engine-like ambient conditions in a spray vessel. Experimental results including liquid/vapor penetration, local liquid volume fraction, droplet size, and projected liquid film on the nozzle tip were compared under ECN G1 (573 K, 3.5 kg/m3), G2 (333 K, 0.5 kg/m3), and G3 (333 K, 1.01 kg/m3) conditions. In addition to the experiments, preferential evaporation process of the E00 fuel was elucidated by Large–Eddy Simulations (LES). The three-dimensional liquid volume fraction measurement enabled by the computed tomographic reconstruction showed substantial plume collapse for E00 under the G2 and G3 conditions having wider plume growth and plume-to-plume interaction due to the fuel high vapor pressure. The CFD simulation of E00 showed an inhomogeneity in the way fuel components vaporized, with more volatile components carried downstream in the spray after the end of injection. The high vapor pressure of E00 also results in ∼4 μm smaller average droplet diameter than IC8, reflecting a higher rate of initial vaporization even though the final boiling point temperature is higher. Consistent with high vapor pressure, E00 had a wider plume cone angle and enhanced interaction with the wall to cover the entire surface of the nozzle tip in a film. However, the liquid fuel underwent faster evaporation, so the final projected tip wetting area was smaller than the IC8 under the flash-boiling condition.
Johnson, Dylan M.; Khakhum, Nittaya; Wang, Min; Warner, Nikole L.; Jokinen, Jenny D.; Comer, Jason E.; Lukashevich, Igor S.
Lymphocytic choriomeningitis virus (LCMV) and Lassa virus (LASV) share many genetic and biological features including subtle differences between pathogenic and apathogenic strains. Despite remarkable genetic similarity, the viscerotropic WE strain of LCMV causes a fatal LASV fever-like hepatitis in non-human primates (NHPs) while the mouse-adapted Armstrong (ARM) strain of LCMV is deeply attenuated in NHPs and can vaccinate against LCMV-WE challenge. Here, we demonstrate that internalization of WE is more sensitive to the depletion of membrane cholesterol than ARM infection while ARM infection is more reliant on endosomal acidification. LCMV-ARM induces robust NF-κB and interferon response factor (IRF) activation while LCMV-WE seems to avoid early innate sensing and failed to induce strong NF-κB and IRF responses in dual-reporter monocyte and epithelial cells. Toll-like receptor 2 (TLR-2) signaling appears to play a critical role in NF-κB activation and the silencing of TLR-2 shuts down IL-6 production in ARM but not in WE-infected cells. Pathogenic LCMV-WE infection is poorly recognized in early endosomes and failed to induce TLR-2/Mal-dependent pro-inflammatory cytokines. Following infection, Interleukin-1 receptor-associated kinase 1 (IRAK-1) expression is diminished in LCMV-ARM- but not LCMV-WE-infected cells, which indicates it is likely involved in the LCMV-ARM NF-κB activation. By confocal microscopy, ARM and WE strains have similar intracellular trafficking although LCMV-ARM infection appears to coincide with greater co-localization of early endosome marker EEA1 with TLR-2. Both strains co-localize with Rab-7, a late endosome marker, but the interaction with LCMV-WE seems to be more prolonged. These findings suggest that LCMV-ARM’s intracellular trafficking pathway may facilitate interaction with innate immune sensors, which promotes the induction of effective innate and adaptive immune responses.
We compare the suitability of various magnesium-based liquid metal alloy ion sources (LMAISs) for scalable focused-ion-beam (FIB) implantation doping of GaN. We consider GaMg, MgSO4●7H2O, MgZn, AlMg, and AuMgSi alloys. Although issues of oxidation (GaMg), decomposition (MgSO4●7H2O), and excessive vapor pressure (MgZn and AlMg) were encountered, the AuMgSi alloy LMAIS operating in a Wien-filtered FIB column emits all Mg isotopes in singly and doubly charged ionization states. We discuss the operating conditions to achieve <20 nm spot size Mg FIB implantation and present Mg depth profile data from time-of-flight secondary ion mass spectrometry. We also provide insight into implantation damage and recovery based on cathodoluminescence spectroscopy before and after rapid thermal processing. Prospects for incorporating the Mg LMAIS into high-power electronic device fabrication are also discussed.
Long-duration energy storage (LDES) is critical to a stable, resilient, and decarbonized electric grid. While batteries are emerging as important LDES devices, extended, high-power discharges necessary for cost-competitive LDES present new materials challenges. Focusing on a new generation of low-temperature molten sodium batteries, we explore here unique phenomena related to long-duration discharge through a well-known solid electrolyte, NaSICON. Specifically, molten sodium symmetric cells at 110 °C were cycled at 0.1 A cm−2 for 1-23 h discharges. Longer discharges led to unstable overpotentials, reduced resistances, and decreased electrolyte strength, caused by massive sodium penetration not observed in shorter duration discharges. Scanning electron microscopy informed mechanisms of sodium penetration and even “healing” during shorter-duration cycling. Importantly, these findings show that traditional, low-capacity, shorter-duration tests may not sufficiently inform fundamental materials phenomena that will impact LDES battery performance. This case highlights the importance that candidate LDES batteries be tested under pertinent long-duration conditions.
Deep geologic disposal of multiple nuclear waste packages with various heat sources can induce nonuniform hydro-thermal behaviors in the near-field of the repository, consequently influencing the long-term radionuclide transport in the far-field once waste form breach initiates. This study looks into three cases with variation in the spatial order of six groups of heat sources (10th, 50th, 75th, 90th, 95th, and 99th percentiles of heat outputs generated from 1,981 as-loaded dual-purpose canisters in the field site) in a shale-hosted repository with respect to the uni-directional groundwater flow (from west to east): (1) cooler waste packages from west to east, (2) hotter waste packages from west to east, and (3) hottest waste packages in the middle of the repository. Our field-scale PFLOTRAN simulation represents heat-driven multiphysics coupled mechanisms, including multiphase flow, heat transfer, and chemical/radioactive transport, and also, calculates the onset of waste form breach based on temperature-dependent canister vitality. The results from this sensitivity study will quantify the short- (less than 1 × 103 years) and long-term (up to 1 × 106 years) impacts of sporadic heat pulses from waste package on the spatio-temporal perturbation in hydro-thermal flow quantities and the rate of radionuclide transport in both near- and far-field of the repository system.
Sandia National Laboratories (SNL) requested a measure of possible human error for each state verification method for a safety mechanism performed at partnering production agencies. A team of three human factors individuals were tasked with conducting observations during site visits of both production agencies in order to complete a Human Reliability Analysis (HRA). A HRA will be used because it provides both qualitative and quantitative reports of human error. This report is the first phase of that effort, which will describe the methods which occur at one of the production agencies.
Despite their noted potential in polynomial-system solving, there are few concrete examples of Newton-Okounkov bodies arising from applications. Accordingly, in this paper, we introduce a new application of Newton-Okounkov body theory to the study of chemical reaction networks and compute several examples. An important invariant of a chemical reaction network is its maximum number of positive steady states Here, we introduce a new upper bound on this number, namely the ‘Newton-Okounkov body bound’ of a chemical reaction network. Through explicit examples, we show that the Newton-Okounkov body bound of a network gives a good upper bound on its maximum number of positive steady states. We also compare this Newton-Okounkov body bound to a related upper bound, namely the mixed volume of a chemical reaction network, and find that it often achieves better bounds.
In this work, we introduce a family of novel activation functions for deep neural networks that approximate n-ary, or n-argument, probabilistic logic. Logic has long been used to encode complex relationships between claims that are either true or false. Thus, these activation functions provide a step towards models that can efficiently encode information. Unfortunately, typical feedforward networks with elementwise activation functions cannot capture certain relationships succinctly, such as the exclusive disjunction (p xor q) and conditioned disjunction (if c then p else q). Our n-ary activation functions address this challenge by approximating belief functions (probabilistic Boolean logic) with logit representations of probability and experiments demonstrate the ability to learn arbitrary logical ground truths in a single layer. Further, by representing belief tables using a basis that associates the number of nonzero parameters with the effective arity of each belief function, we forge a concrete relationship between logical complexity and sparsity, thus opening new optimization approaches to suppress logical complexity during training. We provide a computationally efficient PyTorch implementation and test our activation functions against other logic-approximating activation functions on both traditional machine learning tasks as well as reproducing known logical relationships.
