Piezoelectric acoustic devices that are integrated with semiconductors can leverage the acoustoelectric effect, allowing functionalities such as gain and isolation to be achieved in the acoustic domain. This could lead to performance improvements and miniaturization of radio-frequency electronic systems. However, acoustoelectric amplifiers that offer a large acoustic gain with low power consumption and noise figure at microwave frequencies in continuous operation have not yet been developed. Here we report non-reciprocal acoustoelectric amplifiers that are based on a three-layer heterostructure consisting of an indium gallium arsenide (In0.53Ga0.47As) semiconducting film, a lithium niobate (LiNbO3) piezoelectric film, and a silicon substrate. The heterostructure can continuously generate 28.0 dB of acoustic gain (4.0 dB net radio-frequency gain) for 1 GHz phonons with an acoustic noise figure of 2.8 dB, while dissipating 40.5 mW of d.c. power. We also create a device with an acoustic gain of 37.0 dB (11.3 dB net gain) at 1 GHz with 19.6 mW of d.c. power dissipation and a non-reciprocal transmission of over 55 dB.
We report on a two-step technique for post-bond III-V substrate removal involving precision mechanical milling and selective chemical etching. We show results on GaAs, GaSb, InP, and InAs substrates and from mm-scale chips to wafers.
We report on a two-step technique for post-bond III-V substrate removal involving precision mechanical milling and selective chemical etching. We show results on GaAs, GaSb, InP, and InAs substrates and from mm-scale chips to wafers.
This report details results of a one-year LDRD to understand the dynamics, figures of merit, and fabrication possibilities for levitating a micro-scale, disk-shaped dielectric in an optical field. Important metrics are the stability, positional uncertainty, and required optical power to maintain levitation. Much of the results are contained in a publication written by our academic alliance collaborators. Initial structures were grown at Sandia labs and a test fabrication flow was executed. Owing to our strength in VCSEL lasers, we were particularly interested in calculations and fabrication flows that could be compatible with a VCSEL light source.
We present an optical wavelength division multiplexer enabled by a ring resonator tuned by MEMS electrostatic actuation. Analytical analysis, simulation and fabrication are discussed leading to results showing controlled tuning greater than one FSR.
We present an optical wavelength division multiplexer enabled by a ring resonator tuned by MEMS electrostatic actuation. Analytical analysis, simulation and fabrication are discussed leading to results showing controlled tuning greater than one FSR.