Researchers have been extensively studying wide-bandgap (WBG) semiconductor materials such as gallium nitride (GaN) with an aim to accomplish an improvement in size, weight, and power (SWaP) of power electronics beyond current devices based on silicon (Si). However, the increased operating power densities and reduced areal footprints of WBG device technologies result in significant levels of self-heating that can ultimately restrict device operation through performance degradation, reliability issues, and failure. Typically, self-heating in WBG devices is studied using a single measurement technique while operating the device under steady-state direct current (DC) measurement conditions. However, for switching applications, this steady-state thermal characterization may lose significance since high power dissipation occurs during fast transient switching events. Therefore, it can be useful to probe the WBG devices under transient measurement conditions in order to better understand the thermal dynamics of these systems in practical applications. In this work, the transient thermal dynamics of an AlGaN/GaN high electron mobility transistor (HEMT) were studied using thermoreflectance thermal imaging and Raman thermometry. Also, the proper use of iterative pulsed measurement schemes such as thermoreflectance thermal imaging to determine the steady-state operating temperature of devices is discussed. These studies are followed with subsequent transient thermal characterization to accurately probe the self-heating from steady-state down to sub-microsecond pulse conditions using both thermoreflectance thermal imaging and Raman thermometry with temporal resolutions down to 15 ns.
Al0.26Ga0.74N/GaN on SiC lateral Schottky diodes were fabricated with variable anode-to-cathode spacing and were analyzed for blocking and on-state device performance. On-chip normally-on High Electron Mobility Transistor (HEMT) structures were also fabricated for a comparison of blocking characteristics. The Schottky diode displayed an ideality factor of 1.59 with a Ni/AlGaN zero bias barrier height of 1.18 eV and a flat band barrier height of 1.59 eV. For anode-to-cathode spacings between 10 and 100 μm, an increase in median breakdown voltages from 529 V to 8519 V and median specific on-resistance (Ron-sp) from 1.5 to 60.7 mΩ cm2 was observed with an increase in spacing. The highest performing diode had a lateral figure of merit of 1.37 GW/cm2 corresponding to a breakdown voltage upwards of 9 kV and a Ron-sp of 59 mΩ cm2. This corresponds to the highest Schottky diode breakdown voltage reported thus far with an Al0.26Ga0.74N/GaN lateral structure.
Al-rich AlGaN-channel high electron mobility transistors with 80-nm long gates and 85% (70%) Al in the barrier (channel) were evaluated for RF performance. The dc characteristics include a maximum current of 160 mA/mm with a transconductance of 24 mS/mm, limited by source and drain contacts, and an on/off current ratio of 109. fT of 28.4 GHz and fMAX of 18.5 GHz were determined from small-signal S-parameter measurements. Output power density of 0.38 W/mm was realized at 3 GHz in a power sweep using on-wafer load pull techniques.
In this paper, we present heavy ion and proton data on AlGaN highvoltage HEMTs showing Single Event Burnout, Total Ionizing Dose, and Displacement Damage responses. These are the first such data for materials of this type. Two different designs of the epitaxial structure were tested for Single Event Burnout (SEB). The default layout design showed burnout voltages that decreased rapidly with increasing LET, falling to about 25% of nominal breakdown voltage for ions with LET of about 34 MeV·cm2/mg for both structures. Samples of the device structure with lower AlN content were tested with varying gate-drain spacing and revealed an improved robustness to heavy ions, resulting in burnout voltages that did not decrease up to at least 33.9 MeV·cm2/mg. Failure analysis showed there was consistently a point, location random, where gate and drain had been shorted. Oscilloscope traces of terminal voltages and currents during burnout events lend support to the hypothesis that burnout events begin with a heavy ion strike in the vulnerable region between gate and drain. This subsequently initiates a cascade of events resulting in damage that is largely manifested elsewhere in the device. This hypothesis also suggests a path for greatly improving the susceptibility to SEB as development of this technology goes forward. Lastly, testing with 2.5 MeV protons showed only minor changes in device characteristics.
Photodetectors sensitive to the ultra-violet spectrum were demonstrated using an AlGaN high electron mobility transistor with an GaN nanodot optical floating gate. Peak responsivity of 2 x 109 A/W was achieved with a gain-bandwidth product > 1 GHz at a cut-on energy of 4.10 eV. Similar devices exhibited visible-blind rejection ratios > 106. The photodetection mechanism for $β$-Ga2O3 was also investigated. It was concluded that Schottky barrier lowering by self-trapped holes enables photodetector gain.
AlGaN-channel high electron mobility transistors (HEMTs) are among a class of ultra wide-bandgap transistors that are promising candidates for RF and power applications. Long-channel AlxGa1-xN HEMTs with x = 0.7 in the channel have been built and evaluated across the -50°C to +200°C temperature range. These devices achieved room temperature drain current as high as 46 mA/mm and were absent of gate leakage until the gate diode forward bias turn-on at ~2.8 V, with a modest -2.2 V threshold voltage. A very large Ion/Ioff current ratio, of 8 × 109 was demonstrated. A near ideal subthreshold slope that is just 35% higher than the theoretical limit across the temperature range was characterized. The ohmic contact characteristics were rectifying from -50°C to +50°C and became nearly linear at temperatures above 100°C. An activation energy of 0.55 eV dictates the temperature dependence of off-state leakage.