We report a series of time-resolved spectroscopic measurements that aim to characterize the reactions that occur during shock initiation of high explosives. The experiments employ time-and wavelength-resolved emission spectroscopy to analyze light emitted from detonating thin explosive films. This paper presents analysis of optical emission spectra from hexanitrostilbene (HNS) and pentaerythritol tetranitrate (PETN) thin film samples. Both vibrationally resolved and broadband emission features are observed in the spectra and area as electronic transitions of intermediate species.
Physical vapor deposition is a technique that can be used to produce explosive films with controlled geometry and microstructure. Films of the high explosive hexanitroazobenzene (HNAB) were deposited by vacuum thermal evaporation. HNAB deposits in an amorphous state that crystallizes over time into a polycrystalline material with high density and a consistent porosity distribution. In previous work, we evaluated detonation critical thickness in HNAB films in an effectively infinite slab geometry with insignificant side losses. In this work, the effect of geometry on detonation failure was investigated by performing experiments on films with different thicknesses, while also changing lateral dimensions such that side losses became significant. The experimental failure thickness was determined to be 75.5 μm and 71.6 μm, for 400 μm and 1600 μm wide HNAB lines, respectively. It follows from this that the minimum width to achieve detonation behavior representing an infinite slab configuration is greater than 400 μm.
Cohesive Hamaker constants of solid materials are measured via optical and dielectric properties (i.e., Lifshitz theory), inverse gas chromatography (IGC), and contact angle measurements. To date, however, a comparison across these measurement techniques for common energetic materials has not been reported. This has been due to the inability of the community to produce samples of energetic materials that are readily compatible with contact angle measurements. Here we overcome this limitation by using physical vapor deposition to produce thin films of five common energetic materials, and the contact angle measurement approach is applied to estimate the cohesive Hamaker constants and surface energy components of the materials. The cohesive Hamaker constants range from 85 zJ to 135 zJ across the different films. When these Hamaker constants are compared to prior work using Lifshitz theory and nonpolar probe IGC, the relative magnitudes can be ordered as follows: contact angle > Lifshitz > IGC. Furthermore, the dispersive surface energy components estimated here are in good agreement with those estimated by IGC. Due to these results, researchers and technologists will now have access to a comprehensive database of adhesion constants which describe the behavior of these energetic materials over a range of settings.
