Cross correlations of seismic noise can potentially record large changes in subsurface velocity due to permafrost dynamics and be valuable for long-term Arctic monitoring. We applied seismic interferometry, using moving window cross-spectral analysis (MWCS), to 2 years of ambient noise data recorded in central Alaska to investigate whether seismic noise could be used to quantify relative velocity changes due to seasonal active-layer dynamics. The large velocity changes (>75%) between frozen and thawed soil caused prevalent cycle-skipping which made the method unusable in this setting. We developed an improved MWCS procedure which uses a moving reference to measure daily velocity variations that are then accumulated to recover the full seasonal change. This approach reduced cycle-skipping and recovered a seasonal trend that corresponded well with the timing of active-layer freeze and thaw. This improvement opens the possibility of measuring large velocity changes by using MWCS and permafrost monitoring by using ambient noise.
Active source seismic data was collected at the Nevada National Security Site using the Seismic Hammer(TM) (SH), under contract from HK Exploration. The SH generates a seismic pulse by dropping a 13 metric ton mass from a height of 1.5 m. Post-survey evaluation of collected data revealed inconsistencies in shot trigger time that required additional analysis and correction using cross-correlation and/or time shifts derived from manual picks of trigger times. While the primary analysis for which this data set was collected is independent of the knowledge of shot trigger time, other processing methods require highly precise knowledge of the trigger time. In order to make the Thor data set more usable to the larger community, additional work was undertaken. Results using the preferred method of cross-correlation were found to be satisfactory. An improved timing fiducial approach is required to reduce timing errors.
We present findings from a novel field experiment conducted at Poker Flat Research Range in Fairbanks, Alaska that was designed to monitor changes in active layer thickness in real time. Results are derived primarily from seismic data streaming from seven Nanometric Trillium Posthole seismometers directly buried in the upper section of the permafrost. The data were evaluated using two analysis methods: Horizontal to Vertical Spectral Ratio (HVSR) and ambient noise seismic interferometry. Results from the HVSR conclusively illustrated the method's effectiveness at determining the active layer's thickness with a single station. Investigations with the multi-station method (ambient noise seismic interferometry) are continuing at the University of Florida and have not yet conclusively determined active layer thickness changes. Further work continues with the Bureau of Land Management (BLM) to determine if the ground based measurements can constrain satellite imagery, which provide measurements on a much larger spatial scale.
