With the increasing use of hydrocodes in modeling and system design, experimental benchmarking of software has never been more important. While this has been a large area of focus since the inception of computational design, comparisons with temperature data are sparse due to experimental limitations. A novel temperature measurement technique, magnetic diffusion analysis, has enabled the acquisition of in-flight temperature measurements of hyper velocity projectiles. Using this, an AC-14 bare shaped charge and an LX-14 EFP, both with copper linings, were simulated using CTH to benchmark temperature against experimental results. Particular attention was given to the slug temperature profiles after separation, and the effect of varying equation-of-state and strength models. Simulation fidelity to experiment was shown to greatly depend on strength model, ranging from better than 2% error to a worst case of 22%. This varied notably depending on the strength model used. Similar observations were made simulating the EFP case, with a minimum 4% deviation. Jet structures compare well with radiographic images and are consistent with ALEGRA simulations previously conducted. Sandia National Laboratories is a multimission laboratory managed and operated by National Technology and Engineering Solutions of Sandia, LLC., a wholly owned subsidiary of Honeywell International, Inc., for the U.S. Department of Energy's National Nuclear Security Administration under contract DE-NA-0003525. SAND2017-10009C.
With the increasing use of hydrocodes in modelling and system design, benchmarking of software against experiments has become even more vital. While substantial work has been done in this regard, comparisons with temperature data within dynamic experiments are sparse due to experimental limitations. However, novel developments in measurement techniques has enabled the in-flight acquisition of hypervelocity projectile temperature, providing a new source for validation. This is achieved by tracking the decay of an induced magnetic field which is related to conductivity and further correlated to material temperature. As such, an AC-14 bare shaped charge with a copper lining is simulated using CTH, and benchmarked against experimental temperature results observed by Uhlig and Hummer. Particular attention was given to the slug temperature profiles after separation, and the effect of varying equation-of-state and strength models. Simulations are in agreement with experimental results, with a best case of under 2% error between the observed and simulated temperatures for this shaped charge setup. This varied notably (around 20% variance) depending on strength model. Jet structures compare well with radiographic images and are consistent with ALEGRA simulations previously conducted. SAND2017-3686C.