Publications

Hypervelocity tests of spacecraft optical sensors were conducted to determine if the optical signature from an impact inside the optical sensor sunshade resembled signals that have been observed on-orbit. Impact tests were conducted in darkness and with the ejected debris illuminated. The tests were conducted at the Johnson Space Center Hypervelocity Impact Test Facility. The projectile masses and velocities that may be obtained at the facility are most representative of the hypervelocity particles thought to be responsible for a group of anomalous optical sensors responses that have been observed on-orbit. The projectiles are a few micrograms, slightly more massive than the microgram particles thought to be responsible for the signal source. The test velocities were typically 7.3 km/s, which are somewhat slower than typical space particles.

This report summarizes the advanced development of the Spectrum Sciences Model 5005-TF, Single-Event Test Fixture. The Model 5005-TF uses a Californium-252 (Cf-252) fission-fragment source to test integrated circuits and other devices for the effects of single-event phenomena. Particle identification methods commonly used in high-energy physics research and nuclear engineering have been incorporated into the Model 5005-TF for estimating the particle charge, mass, and energy parameters. All single-event phenomena observed in a device under test (DUT) are correlated with an identified fission fragment, and its linear energy transfer (LET) and range in the semiconductor material of the DUT.

Are single event upsets an important vulnerability or lethality issue for strategic systems Neutron-induced single events have become a part of the vulnerability analysis for nuclear weapon environments, but there has been no serious consideration of proton-induced single events from neutron particle beam environments. Is this appropriate This paper examines this concept.

Recent experimental works on the effect of dose rate on the total dose failure threshold of MOS devices have shown that the failure level is strategic environments may be less than the failure level measured in the laboratory by a factor of 3 to 10. This difference in dose rate response raises concerns about using laboratory sources to predict the radiation hardness in strategic environments. A solution to the problem of determining the total dose hardness of piece parts is to perform lot acceptance testing at relevant dose rates such that the time dependent effects can be directly observed. A low cost method of measuring the total dose hardness of piece parts in the laboratory at requisite dose rates is presented. 11 refs., 5 figs.