Publications Details
Response of elastomeric packaging components to a corrosive simulant mixed waste
The purpose of hazardous and radioactive materials packaging is to enable these materials to be transported without posing a threat to the health or property of the general public. To achieve this aim, regulations in the US have been written establishing general design requirements for such packagings. While no regulations have been written specifically for mixed waste packaging, regulations for the constituents of mixed wastes, i.e., hazardous and radioactive substances, have been codified by the US Department of Transportation and the US Nuclear Regulatory Commission. Based on these national requirements, a Chemical Compatibility Testing Program was developed in the Transportation Systems Department at SNL. In this paper, the authors present the results of Part B of the second phase of this testing program. The first phase screened five liner materials and six seal materials towards four simulant mixed wastes. Part A of the second phase involved the comprehensive testing of five candidate liner materials to an aqueous Hanford Tank simulant mixed waste. Part B involved similar testing on elastomeric materials, ethylene-propylene and butadiene-acrylonitrile rubber. The comprehensive testing protocol involved exposing the respective materials to a matrix of four gamma radiation doses ({approximately}1, 3, 6, and 40 kGy), three temperatures (18, 50, and 60 C), and four exposure times (7, 14, 28, and 180 days). Following their exposure to these combinations of conditions, the materials were evaluated by measuring six material properties. These properties were specific gravity, dimensional changes, hardness, vapor transport rates, compression set, and mechanical properties.