Publications Details
High power ion beam (HPIB) modification of one- and two-layer metal surfaces
Intense pulsed high-power ion beams have been demonstrated to produce enhanced surface properties by changes in microstructure caused by rapid heating and cooling of the surface. Additional improvements can be effected by the mixing of a previously deposited thin-film layer (surface alloying or ion beam mixing) into any number of substrate materials. The authors have conducted surface treatment and alloying experiments with Al, Fe, and Ti-based metals on the RHEPP-1 accelerator (0.8 MV, 20 W, 80 ns FHWM, up to 1 Hz repetition rate) at Sandia National Laboratories. Ions are generated by the MAP gas-breakdown active anode, which can yield a number of different beam species including H, N, and Xe, depending upon the injected gas. Enhanced hardness and wear resistance have been produced by treatment of 440C stainless steel, and by the mixing of Pt into Ti-6Al-4V alloy. Mixing of a thin-film Hf layer into Al 6061-T6 alloy (Al-1.0Mg-0.6Si) has improved its corrosion resistance by as much as four orders of magnitude in electrochemical testing, compared with untreated and uncoated Al6061. Experiments are ongoing to further understand the microstructural basis for these surface improvements.