Publications Details

Publications / SAND Report

Hanging String Cuts in SPR Caverns: Modeling Investigation and Comparison with Sonar Data

Zeitler, Todd Z.; Chojnicki, Kirsten C.

Investigation of leaching for oil sales includes looking closely at cavern geometries. Anomalous cavern "features" have been observed near the foot of some caverns subsequent to partial drawdowns. One potential mitigation approach to reducing further growth of preexisting features is based on the hypothesis that reducing the brine string length via a "string cue' would serve to move the zone associated with additional leaching to a location higher up in the cavern and thus away from the preexisting feature. Cutting of the hanging string is expected to provide a control of leaching depth that could be used to "smooth" existing features and thus reduce geomechanical instability in that region of the cavern. The SANSMIC code has been used to predict cavern geometry changes (i.e., the extent of cavern growth with depth) based on variable input parameters for four caverns: West Hackberry 11 (WH11), West Hackberry 113 (WH113), Big Hill 104 (BH104), Big Hill 114 (BH114). By comparing the initial sonar geometry with resultant geometries calculated by the SANSMIC code, conclusions may be drawn about the potential impact of these variables on future cavern growth. Ultimately, these conclusions can be used to assess possible mitigation strategies such as the potential advantage of cutting versus not cutting a brine string. This work has resulted in a recommendation that a hanging string cut of 80 ft in WH11 would be beneficial to future cavern geometry, while there would be little to no benefit to string cuts in the other three caverns investigated here. The WH11 recommendation was followed in 2019, resulting in an operational string cut. A sonar performed after the string cut showed no adverse leaching in the area of the preexisting flare, as expected from the results of the preliminary SANSMIC runs described in this report. Additional SANSMIC modeling of the actual amount of injected raw water resulted in good agreement with the post-cut sonar.