Publications Details

An interim report on testing the molten salt pump and valve loops

Rush, E.E.; Chavez, J.M.; Matthews, C.W.; Bator, P.

This interim report provides results of the molten salt pump and valve loop testing, lessons learned, and recommendations based on the test results to date. The molten salt pump and valve test loop is intended to demonstrate the effectiveness of full-scale hot and cold salt pumps and valves. The pump and valve testing consists of two pumped loops, one to simulate the hot side of the receiver (565{degree}C, referred to as the hot loop) and one for the cold side (285{degree}C, referred to as the cold loop). Each loop contains a pump and six representative valves scaled for a 60-MW{sub e} commercial solar power plant using molten salt heat transport fluid. The test loop is part of the Molten Salt Subsystem/Component Test Experiment (MSS/CTE), which is being conducted to reduce the technical risk of building and operating commercial solar central receiver plants. The project, managed by Sandia National Laboratories (SNL) with Babcock and Wilcox (B W) as the prime contractor, is cost shared by DOE and six contractors. The hot loop has operated over 2400 hours in the fully automatic sequence mode. The last 500 hours have been through continuous 24-hour, 7-day operation. The hot pump operation hours simulate over 2 years of pump cycles. The cold loop has operated 12 hours in the manual mode; this is because of problems caused in the manufacturing of the pump and motor. 9 refs., 6 figs., 1 tab.