4.10. Boundary Conditions

Every exposed surface in your mesh must have a sideset on it, and every sideset must have a boundary condition applied. Fuego will throw an error at runtime if these conditions are not met. Boundary conditions are specified in the Fuego Region block, and the available options are described in this section.

• 4.10.1. Open
  • 4.10.1.1. Entrained Momentum
  • 4.10.1.2. Entrained Turbulence Quantities
  • 4.10.1.3. Total Pressure
  • 4.10.1.4. Sponge Layer
• 4.10.2. Inflow
  • 4.10.2.1. Use Fluxes
• 4.10.3. Wall
  • 4.10.3.1. Turbulent Wall Modeling
  • 4.10.3.2. Post-Processing
  • 4.10.3.3. Conjugate Heat Transfer
  • 4.10.3.4. Convection Coefficients
• 4.10.4. Wall Mass Inject
  • 4.10.4.1. Specified Injection
  • 4.10.4.2. Pool Model
• 4.10.5. Symmetry
• 4.10.6. Periodic
• 4.10.7. Mass Flux
• 4.10.8. Composite
  • 4.10.8.1. 1D Composite Model
  • 4.10.8.2. Composite Interface
• 4.10.9. Fixed
• 4.10.10. Heat Flux
• 4.10.11. Non-Conformal